3NOVATICA 1Kg Spool 1.75mm Blue PLA Filament

$50.00

3NOVATICA 1Kg Spool 1.75mm Blue PLA Filament

  • 3NOVATICA Blue PLA Filament 1.75mm is compatible with 3NOVATICA FLEXA 3D printer
  • High grade, high-density 3D printing filament
  • Easy extrusion due to their tight laser-controlled tolerances
  • Comes in one diameter that fits many brands of printers

Description

The 3NOVATICA Blue PLA Filament 1.75mm is compatible with 3NOVATICA FLEXA 3D printer. This is a high grade, high-density 3D printing filament. Filament is perfectly suited for and tested for a wide range of 3D printers. 3NOVATICA PLA filaments allow for easy extrusion due to their tight laser-controlled tolerances, smooth flow characteristics over a large temperature range, rapid cooling, and a high tensile strength. Filament comes in a wide range of colors and in two diameters that fit many brands of printers.

PLA is a good choice for a printing material if you are looking for high accuracy and high resolution. It extrudes at lower temperatures, does not require a heated base, and has a very low shrinkage rate (0.3%). PLA is harder than ABS, but is therefore also a bit more brittle. Additionally, PLA is a plant-based plastic, which means that it is biodegradable and gives off a slightly sweet odor, like roasting corn.

This 1 Kg spool features a thickness of 1.75mm ±0.10mm, with a roundness variation of only 0.03mm. It has a nominal processing temperature of 210° C (410°F). Thickness and roundness factors are laser measured at the factory to ensure accuracy over the entire length of the filament. The negatives of using PLA is that it is vulnerable to degradation from moisture, sunlight, and heat. Additionally, it is more prone to overheating during processing, which can cause dripping and drooping if it gets too hot.

Additional information

FILAMENT TYPE

PLA Filament

COLOR

Blue

BRAND

3NOVATICA

Reviews

There are no reviews yet.

Be the first to review “3NOVATICA 1Kg Spool 1.75mm Blue PLA Filament”

Your email address will not be published. Required fields are marked *

Post comment